Mr300s, I hate to be the bearer of bad news, but your gonna have troubles trying to run cutting master with your $69.00 copy of X-4. If you're having the same problem as me I hope this helps, would love to hear of any other solutions out there that might make it easier. Now here's my question - Isn't there an easier way?! Anyone have any ideas, thoughts or suggestions? The wife has started to ask me why my forehead seems to be getting flatter. I'm going to try it again with another graphic and see what happens. I hope I didn't miss a step in the above, I think I got it all. So between the 3 dialog boxes, Corel (Cut/Plot), Cutting Master 2 and the Graphtec Cutting Plotter Controller - I have some what figured it out. In Flexi it has to be set to Hp-GL) I could be wrong but that how it works for me.

(Note the GP-GL, in my case, is for Corel only. Selected the 'Advanced' button on the right, selected the 'Command' button and changed it from HG-PL to GP-GL. Also made sure I had the correct type mark selected. I then opened the 'CE5000 Cutting Plotter Controller' selected 'Use Controller Settings' and under 'Registration Marks - Distance' put in the dimensions (size) of the registration marks - Went to the 'settings' put in the correct length and select '2 Point' instead of 4 point. I found this on the forum that says your Graphtec has to be on GP-GL this info is in the Corel thread, I just entered the whole passage from the thread, they are referring to registration marks and how to run using corelx4 and graphtec.

I found this on the forum, I do not know anything about Corelx4 was just searching around, Maybe some of this info will help you,

Cutting master 4 illustrator 2021